Gianpaolo Macario's blog
HomePosts

Preparing my Arduino YUN for the Arduino Day

Hi there!

Tomorrow I will be attending the Arduino PRO Workshop at the Arduino DAY 2015 here in Torino.

Time to do some preparation...

Restore Arduino Yun factory settings

Reference: http://arduino.cc/en/Main/ArduinoBoardYun

  1. Plug MicroUSB to power up Yun
  2. Press and hold the WiFi Reset button for 30 seconds to restore factory settings
  3. From the laptop search for a WiFi network Arduino-Yun-xxxxxx and connect to it
  4. Browse http://arduino.local/ (or http://192.168.240.1)

Welcome to your Arduino Yun. Please enter password to access the web control panel

Password: xxxx

The default factory password is arduino

Configure Arduino Yun networking

After successfully logging in you should get the following page (your actual data may vary):

WELCOME TO ARDUINO, YOUR ARDUINO YUN

WIFI (WLAN0) CONNECTED

  • Address: 192.168.240.1
  • Netmask: 255.255.255.0
  • MAC Address: 90.A2:DA:F3:0C:7B
  • Received: 72.79 KB
  • Transmitted: 146.48 KB

WIRED ETHERNET (ETH1): DISCONNECTED

  • MAC Address: 90:A2:DA:FB:0C:7B
  • Received: 0.0 B
  • Transmitted: 0.0 B

You can change defaults by selecting the "CONFIGURE" button, which will you return the following page:

For more advanced network configuration features, see the advanced configuration panel (luci)

YUN BOARD CONFIGURATION

  • YUN NAME: Arduino
  • PASSWORD: _
  • CONFIRM PASSWORD: _
  • TIMEZONE: Rest of the World (UTC)

WIRELESS PARAMETERS

  • CONFIGURE A WIRELESS NETWORK: Yes
  • DETECT WIRELESS NETWORKS (Select a wifi network...)
  • WIRELESS NAME: _
  • SECURITY: None

(DISCARD) (CONFIGURE & RESTART)

REST API ACCESS

  • REST API ACCESS: ( ) OPEN (X) WITH PASSWORD

REST APIs allow you to access your sketch from the web, sending commands or exchanging configuration values. If your Yun is on a public network, or controlling sensitive equipment, or both, we recommend you leave the REST API password protected.

You may attach to an existing WiFi network by setting the appropriate wireless parameters, then selecting the "CONFIGURE & RESTART" button

See also: http://fibasile.github.io/arduino-yun-getting-started.html

Run a simple sketch on my Arduino Yun

TODO

Learn about Temboo

Reference: https://www.temboo.com/arduino/yun/

Getting started with Temboo on your Arduino Yun

From https://www.temboo.com/arduino/yun/getting-started

  1. Log in to Temboo.
    • Example: gmacario/xxx
  2. Go to our Library and find the Yahoo > Weather > GetWeatherByAddress Choreo.
  3. Enter any complete address in the Address input field.
    • Example: Via Egeo, 2 Torino Italy
  4. Now click Run. After a moment you'll see the data that Yahoo Weather sends back shown in the Output section of the page (which is right below the Input section).

Make your Arduino Sketch

  1. Turn on IoT Mode and select Arduino Yun.

TODO